Erase All Settings, Software Reset; Carry Out Hardware Reset - RADEMACHER 1623 45 Operating And Assembly Manual

19. Erase all settings, software reset

If necessary, you can
erase all of your settings
and return the RolloTron
Comfort DuoFern system to
its original factory settings.
1.
Simultaneously press and
hold all four keys for 5
seconds, until all of the
icons are shown on the
display.

20. Carry out hardware reset

A hardware reset can be carried out in the event that the
RolloTron Comfort DuoFern fails to react to commands.
◆ A hardware reset causes the internal power supply
to the RolloTron Comfort DuoFern to be briefly
interrupted.
◆ All of the previously configured settings will be
saved apart from the time and date.
IMPORTANT
Never press the reset button when the motor is running,
as otherwise the end points will be modified.
2.
Next, the device's software
version will be displayed
for a few seconds.
All settings will be erased
and reset to the default
factory settings.
Carry out the settings
again as specified from
page 26 onwards (installation
wizard).
1.
Press the Reset button using a sharp
object (e.g. a paper clip).
EN
73