Drawing In And Fastening The Belt - RADEMACHER 1623 45 Operating And Assembly Manual

i

12. Drawing in and fastening the belt

1.
Insert the mains plug into the socket.
2.
Press the [ Up ] key until the fastening hooks
are easily accessible in the reel compartment.
There is a risk of injury
from the reel.
◆ Never reach into the reel compartment when the
motor is running.
3.
Always remove the mains plug from the socket before
feeding the belt into the top of the RolloTron.
◆ Continue to feed the belt into the device as shown in
the bottom right sectional diagram and subsequently
slide the belt over the fastening hooks from above.
4.
Re-insert the mains plug into the socket.
◆ Press the [ Up ] key until the belt has wound completely
once around the reel.
◆ Pull the belt tight when winding, so that the deflection
roller turns at the same time.
5.
Finally remove the mains plug from the socket again
before replacing the reel compartment cover back onto
the reel compartment.
Belt
Fastening
hooks
EN
Belt
End of belt
Belt path in
RolloTron Comfort DuoFern
21