i
9.3 Software update
The HomePilot® is continually updated through firmware updates.
1.
Open the user interface of the HomePilot®.
2.
Go to the "Configuration / System / Firmware" menu and check
to see if an update is available.
3.
Start the update (if available).
4.
The installation can be started once the update has been success-
fully downloaded. The LED
5.
The HomePilot® is rebooted after approx. 15 minutes. The
LED flashes orange and the LED
This process may take several minutes. The HomePilot® is not
ready for use during this phase.
6.
A further reboot of the HomePilot® occurs in order to access the
normal operating mode.
The
7.
The HomePilot® is ready for use again as soon as the
LED lights up green again continuously.
i
28
LED flashes orange during this phase.
The entire update process takes approx. 30 minutes
plus the time for the download of the update.
flashes during this time.
flashes green.
EN