Setting Up The Printer; Interface Connection; Power Connection - Postek G2000e User Manual

G2000e/G3000e/G6000e User's Manual

2.2 Setting up the Printer

2.2.1 Interface Connection

When connecting the Ge Series printer to a computer via the USB interface cable, make sure to
utilize the same USB port used during the driver installation process. If the same USB port is not
available or not known, then please go to the printer driver's Properties Dialogue Box, and make
sure the correct port is checked under the Ports tab.
The Ge Series printer supports RS-232 Serial, USB Device, and 10/100 M Adaptive Ethernet
interface connections. Centronics parallel connection requires an optional Centronics Parallel
Interface Card.
To connect:
•
Make sure the printer is powered OFF.
•
The printer will identify the communication port automatically.
•
The default values of printer port can be obtained from the self-test report. (Please refer to
Advanced Functions/Obtaining Printer Configuration
•
Cable configurations for Serial (RS-232C) interface can be found in
Specifications of this guide.
•
Please take the following measures to reduce cable noise.
➢ Restrict the length of the interface cable to less than 6' (1.83 M) if possible.
➢ Keep the interface cable separate from power cords.

2.2.2 Power Connection

•
Do not use the printer near liquids or corrosive chemicals.
•
Using a wrong power adapter may cause damage to your printer. POSTEK assumes no
liability for any damage in such cases. The rating for the printer is 24VDC.
1. Make sure the printer is switched OFF.
2. Connect the power cord to the Power Adapter.
3. Connect the Power Adapter's DC output plug to the DC In Port on the back of the printer.
4. Plug the power cord into a live wall outlet.
Information)
Appendix A: Interface
Chapter 2: Setup and Use
3.1.3
9