Postek G2000e User Manual page 3

corresponding user's manual before operation, and don't use the printer during abnormal conditions.
In no event shall POSTEK be liable for any damage or loss caused by human misoperation,
including but not limited to loss of business profits, business interruption, loss of business
information, or other pecuniary loss.
Although this manual describes and details many issues which could possibly occur, the
manufacturer cannot warrant against unpredictable conditions during the printer's application. For
problems such as the printer not working, missed or unclear print content, etc., POSTEK and/or its
resellers are responsible for troubleshooting (according to POSTEK Warranty Clauses). In no event
shall POSTEK or the resellers involved be liable for any direct or indirect loss, including but not
limited to loss of business profits, business interruption, loss of business information, or other
pecuniary loss.
Important Safety Instructions
•
Only qualified and trained service technicians should attempt to repair the printer.
•
Do not place the printer on or near a heat source.
•
Be sure that the output of the power adapter is 24VDC and your power source matches the
rating listed on the power adapter. Be certain your power source is grounded.
•
To avoid getting an electric shock, do not use a worn or damaged power cord. If the power cord
becomes damaged or frayed, replace it immediately.
•
Do not insert anything into the ventilation slots or openings on the printer.
•
The printer and power adapter should never be operated in a location where either one can get
wet. Personal injury may result.
•
The printhead becomes hot while printing. To protect from damaging the printhead and risk of
personal injury, avoid touching the printhead.
•
To get increased printhead longevity and higher quality printouts, always use approved labels,
tags and thermal transfer ribbons. Approved supplies can be ordered from your Postek
authorized reseller.
•
Static electricity that accumulates on the surface of the human body or other surfaces can
damage or destroy the printhead or electronic components in this device. DO NOT touch the
printhead or the electronic components with bare hands.
•
Place the printer on a flat, firm, solid surface.
•
Never operate in a high temperature environment.
•
Turn off the power when not in use for extended periods.
•
Follow all recommendations and setup instructions included in this manual.