Advertisement
Removing Bypass Jumpers
A. After all load wiring has been checked, turn
circuit breakers OFF.
B. Use the tool provided to remove the bypass
jumpers and store them for possible future use.
(Removal is shown at right.)
C. Turn circuit breakers ON.
Note: Re-use the bypass jumpers whenever
work is being done on a load. Damage
caused by short-circuits and miswiring is not
covered by the product warranty.
R
Hook bypass
jumper with tip of
removal tool
Bypass jumper
Installation Guide for Lighting Zone Controllers
This page applies to:
Small
Std.
Panel
Panel
Rock tool to side to lift
out bypass jumper from
terminal block
Bypass jumper
removed
17
Advertisement
