Table of Contents
Advertisement
General Information
Safety Instructions
Only qualified personnel are permitted to transport, assemble, install, and maintain this equipment.
Properly qualified personnel are persons who are familiar with the transport, assembly, installation,
commissioning and operation of motors, and who have the appropriate qualifications for their jobs. The
qualified personnel must know and observe the following standards and regulations:
IEC 364 resp. CENELEC HD 384 or DIN VDE 0100
IEC report 664 or DIN VDE 0110
National regulations for safety and accident prevention or VBG 4
Read all available documentation before assembly and installation. Incorrect handling of products in this
manual can result in injury and damage to persons and machinery. Strictly adhere to the technical
information on the installation requirements.
It is vital to ensure that all system components are connected to earth ground. Electrical safety is
impossible without a low-resistance earth connection.
®
The SERVOSTAR
product contains electrostatically sensitive components that can be damaged by
incorrect handling. Discharge yourself before touching the product. Avoid contact with high insulating
materials (artificial fabrics, plastic film, etc.). Place the product on a conductive surface.
During operation keep all covers and cabinet doors shut. Otherwise, there are deadly hazards that could
possibility cause severe damage to health or the product.
In operation, depending on the degree of enclosure protection, the product can have bare components that
are live or have hot surfaces. Control and power cables can carry a high voltage even when the motor is
not rotating.
Never pull out or plug in the product while the system is live. There is a danger of electric arcing and
danger to persons and contacts.
After powering down the product, wait at least 10 minutes before touching live sections of the equipment
or undoing connections (e.g. contacts, screwed connections). Capacitors can store dangerous voltages for
long periods of time after power has been switched off. To be safe, measure the contact points with a
meter before touching.
The safety-alert symbols contained in this manual are:
"Warning" alerts users to potential danger or harm. Failure to follow warning notices could
result in personal injury or death.
"Caution" directs attention to general precautions, which if not followed, could result in
personal injury and/or equipment damage.
"Note" highlights information critical to the users understanding or use of these products.
When these symbols are seen in this manual, be alert to the potential for personal injury. Follow the
recommended precautions and safe operating practices included with the alert symbols. Safety notices in
this manual provide important information. Read and be familiar with these instructions before attempting
installation, operation, or maintenance. The purpose of this section is to alert users to possible safety
hazards associated with this equipment and the precautions that need to be taken to reduce the risk of
personal injury and damage to the equipment. Failure to observe these precautions could result in serious
bodily injury, damage to the equipment, or operational difficulty.
®
SERVOSTAR
SBD-Series ST/CT Product Family
Danaher Motion
iii
Advertisement
Table of Contents
