Other Specifications; Operating Modes And Nominal Output Parameters - ConMed SYSTEM 5000 Operator's Manual

1.2.10 Other Specifications

Power Cord: All units supplied with an IEC-320 250V 10A 65°C mains inlet connector. Power cords can
be ordered from CONMED Electrosurgery or obtained from other sources if the following specifications are
met:
Region Specification
USA, Any UL, CSA
Canada manufacturer
Europe Any HAR cord
manufacturer
Weight: 21.5 lb. (9.75 Kg)
Height: 5.5 inches (14 cm); Width: 13.5 inches (35 cm); Depth: 21.5 inches (48 cm) including handle
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE

1.2.11 Operating Modes and Nominal Output Parameters

Mode Max
Power
(watts)
Monopolar
Pure Cut 300
Blend 1 200
Blend 2 200
Blend 3 200
Pinpoint Coag 120
Standard Coag 120
Spray Coag 80
Bipolar
Micro Coag 50
Macro Coag 90
*Measured in the open circuit condition.
•Activation of Pulse Cut will make the selected cut mode, Pure Cut, Blend 1, Blend 2, or Blend 3 active for
70 milliseconds every 600 milliseconds.
•Activation of Pulse Coag will make the selected coag mode, either Standard or Spray, active for 2.5 mil-
liseconds every 5 milliseconds. Displayed power setting will represent the average power being delivered
which is approximately half the power delivered during the pulses.
•LAP Specialty Mode output parameters match general operation parameters except the maximum voltage
is limited to less than 2700 Volts peak.
•FLUIDS Specialty Mode output parameters match general operation parameters with an initial energy
boost upon activation to initiate an arc.
Description
SJT or better 250VAC, minimum 16AWG, 3 Conductor, maxi-
mum length 20 feet (6m)
<HAR>H05WF3G1.0 Copper 1.0mm2 minimum cross sectional area,
maximum length 20 feet or 6.0m
Rated Typical
Load Crest
(ohms) Factor
500 1.4 - 1.7
500 1.5 – 1.9
500 1.8 – 2.4
500 2.4 – 2.9
500 3.7 - 4.6
500 5.6 – 6.6
500 7.1 – 9.7
50 1.5 – 1.9
300 1.6 - 2.0
Max Open Max
Circuit Loaded
Voltage Voltage
(Peak) (Peak)
800 820
860 930
1100 1100
1480 1480
2120 2120
3140 3500
6350 6350
170 180
610 610
Standard
UL817
IEC60799
Carrier Pulse
Freq. Repetition
(KHz)* Freq. (KHz)
391 N/A
391 20.0
391 20.0
391 20.0
391 20.0
562 39.0
562 19.5
391 N/A
391 N/A
1-11