Muratec MFX-2530 Operating Instructions Manual page 176

Just in case
< Fax >
What you see on the
LCD
1 location or less
30 locations or less
Already stored
Box in use
Check # of documents
Commands full
5.12
What it means/What to do
You tried to enter too many forwarding numbers
for fax forwarding through the numeric keypad.
You can enter up to 201 forwarding numbers by
using one-touch key, speed dial number, group
number and numeric keypad, but you can enter
only 1 location by using numeric keypad (see
pages 3.36–3.37).
You tried to enter too many numbers for broad-
cast through the numeric keypad.
You can enter up to 230 numbers for broadcast
using one-touch keys, speed dial numbers or
group numbers, however you can enter only 30
locations by using the numeric keypad.
Press [Cancel] to delete the extra numbers and
then try again.
You tried to enter a same number, department
code or sub-address which is already entered in
your machine.
Enter a different number, department code or
sub-address.
You tried to erase a F-Code box which contains
at least one document.
Erase the document(s), then try again.
You placed fewer pages into your fax machine
than you indicated in your page-numbering set-
ting (see page 3.41). Carefully recount the pages
in your document, then retry the transmission,
being sure to enter the correct number of pages if
you use the page-numbering function.
Your fax machine has all of its 100 possible
delayed commands (automatic redialing counts
as one) stored in memory and cannot accept
another. Delete an existing command by using
, or wait until your fax has
REVIEW COMMANDS
completed one of the delayed commands.
Communication Error
Document full
Document is in the ADF
Document stored
Enter number (0-32)
Hang Up Phone
Invalid I.D. code
Invalid Number
A communication error disrupted the transmis-
sion or reception. If you were transmitting, press
to clear the error message and then retry
STOP
the transmission. If you were receiving a fax, try
to contact the other person and have them retry
the transmission. (The problem may be entirely
with their machine, phone line, etc.)
You tried to enter an document into Batch box
or an F-Code box, but the machine has reached
its capacity. Delete documents stored in boxes
until the machine will let you proceed.
The command you're trying to enter requires the
use of the , which is already in use. Wait for
ADF
the machine to stop using the , then try
ADF
again.
You tried to erase a batch box which contains at
least one document. Erase the document(s), then
try again.
. . . or . . .
You tried to store the polling document in your
fax machine, where one already had been
stored. Wait for the fax to complete the regular
polling operation, then try again.
. . . or . . .
A received document was in your fax's memory
when you tried to turn off the security reception
passcode. Print the received document from your
fax's memory, then retry the desired operation.
You tried to enter a call group number greater
than 32. Your machine can maintain 32 call
groups, numbered 1-32 (call group 0 covers all
the groups). Determine the correct call group
identifier number and enter it, instead.
The optional handset is off-hook.
Hang it up, making sure the upper part of the
handset presses down on the "hook" button.
The F-Code box . . code you entered isn't valid.
I D
Try re-entering your F-Code box . . code.
I D
You entered the incorrect number which has no
function during the current operation.