Muratec MFX-2530 Operating Instructions Manual page 160

Common settings
Sending a fax using a department code
For this operation to work, two things must be true:
• The four-digit department code must exist on your fax machine.
• You must know the department code or department ID.
1
Place the document and select resolution and contrast you require.
2
Enter the fax number by either pressing a one-touch key, entering a speed-
dial number or dialing from the numeric keypad.
If you enter the fax number using a one-touch key, skip to step 4.
Otherwise, go on to step 3.
3
Press .
START
4
If you select the department code for the department mode in the previous
column, proceed to step 5.
If you select the department ID for the department mode, skip to step 6.
5
Use the numeric keypad to enter the appropri-
ate four-digit department code.
Skip to step 7.
6
Use the one-touch keys or the numeric keypad
to enter the appropriate department ID.
7
Press [Enter].
4.14
Transmission
Enter department code.
0000
123-4567
Enter
Transmission
Enter department ID.
_
123-4567
Clear Enter
Making a copy using a department code
For this operation to work, two things must be true:
• The four-digit department code must exist on your fax machine.
• You must know the department code or department ID.
Note: If you press [No Copy] in step 4 or 5 below, you can set a copy setting or
print a list without entering the department code.
1
Place the document and set any settings you want.
2
Use the numeric keypad to enter the number of copies.
3
Press .
START
If you select the department code for the department mode above, proceed to
step 4.
If you select the department ID for the department mode above, skip to step
5.
4
Use the numeric keypad to enter the appropri-
ate four-digit department code.
Skip to step 6.
5
Use the one-touch keys or the numeric keypad
to enter the appropriate department ID.
6
Press [Enter].
Department Codes
Enter department code.
0000
No Copy Enter
Department Codes
Enter department ID.
_
No Copy Clear Enter