Setting For Use With A Closed Network; Setting Block Junk Fax - Muratec MFX-2530 Operating Instructions Manual

Setting for use with a closed network

For maximum communications security, use a closed network. This limits your
machine to only communicating with other Muratec fax machines which can "pre-
sent" the proper passcode.
Important: The passcode you use for closed network operation is not the same as
the protection passcode.
Once your machine is set up for a closed network, your machine will disconnect calls
coming in from fax machines other than Muratec fax machines.
To set your fax machine's closed network password:
1
Decide on the four-digit closed network passcode (0001–9999) you want to use.
Write it down, and put it in a safe place.
2
Press , , 0, 8, [Enter].
MENU J
The shows the current code:
LCD
3
Use the numeric keypad to enter the desired
four-digit closed network passcode.
4
Press [Enter] to save the setting.
Note: To turn off the closed network passcode and return to normal fax reception,
change the code to 0000 by repeating steps 1–4 and entering 0000 in step 3.
To set your fax machine to operate in a closed network:
1
Press , , 0, 9, [Enter].
MENU J
The shows your fax's current setting:
LCD
2
Select desired mode.
3
Press [Enter] to save the setting.

Setting Block Junk Fax

Your fax machine's Block Junk Fax feature lets you bar the gates against unautho-
rized incoming faxes ("junk fax"). But before you block junk fax, first understand
how this feature works, to determine if it's right for you. There are four possible set-
tings for Block Junk Fax:
• Off — The feature isn't activated.
• Mode1 — Your fax machine checks whether the last four digits of any phone
• Mode2 — This mode rejects any call from a number whose last eight digits
08.Passcode
Enter the passcode.
• Mode3 — This rejects numbers that are not in the autodialer and also rejects num-
0000
Passcode :0000
But before you activate the Block Junk Fax feature, please consider:
Enter
• Not all fax machine owners enter their phone numbers in their Subscriber
• Access codes can cause confusion. — If an autodialer entry ends with extra codes,
09.Closed Network
To set Block Junk Fax:
Use cursor to select
ON or OFF.
ON
OFF
Enter
number in your autodialer matches the last four digits of the remote fax's sub-
scriber (the phone number part of the
ID
machine disconnects the call.
match any number in the blocked numbers list (explained later). Your machine
can hold up to 30 blocked numbers.
bers that are in the blocked numbers list. This lets you keep a number on your
autodialer for transmission to it, while still blocking its incoming calls by putting
it in the blocked numbers list.
With Block Junk Fax activated, your machine would reject faxes from these
machines.
such as long-distance codes, Block Junk Fax will block out calls from those faxes.
1
Press , , 1, 1, [Enter].
MENU J
The shows your fax's current setting:
LCD
2
Select desired mode.
3
Press [Enter] to save the setting.
What you do next depends on what you selected
in step 2:
• If you selected Off or Mode1, press
• If you selected either Mode2 or Mode3, go on to step 4.
Advanced fax
). If it doesn't find a match, your
TTI
s. —
ID
11.Block Junk Fax
Use cursor to select
desired mode.
OFF
Mode1
Mode2
Mode3
Enter
to return to standby mode.
RESET
3.65