Table of Contents
Advertisement
Example 2: Input the paired-variable data shown below (which is the same data as
Example 1), and then draw the regression graph without performing regression
calculation.
list1 = 0.5, 1.2, 2.4, 4.0, 5.2
list2 = –2.1, 0.3, 1.5, 2.0, 2.4
Cla
Pad Operation
(1)
(2) Input the data shown above.
(3) Tap [SetGraph] and then [Setting...], or tap
(4) On the Set StatGraphs dialog box that appears, configure a StatGraph setup with the
settings shown below, and then tap [Set].
Draw: On
Type: LogR
XList: list1
YList: list2
(5) Tap
to graph.
Graphing Previou ly Calculated Regre
Performing the following procedure graphs the last set of regression results you calculated.
Use this procedure when you want to perform statistical calculations without graphing first,
and then graph the results.
Cla
Pad Operation
(1) [SetGraph]
(2) On the menu that appears, select the [Previous Reg] check box.
(3) Tap the Graph window or
Tip
• Calculated regression results are stored in memory whenever you perform a regression
calculation from the Stat Editor menu or from the Statistical Graph [Calc] menu.
• The [Previous Reg] check box described in step (2) above is selected automatically whenever
you perform a regression calculation from the Stat Editor menu or from the Statistical Graph [Calc]
menu.
7-5-4
Graphing Paired-Variable Statistical Data
to graph the last set of regression results you calculated.
20060301
.
ion Re ult
Advertisement
Table of Contents
