Table of Contents
Advertisement
Switch~Ca e~Default~SwitchEnd
Syntax:
Switch
<expression 1>
Case
<expression 2>
[<statement>] ...
Break
Case
<expression 3> ...
[<statement>] ...
Break
...
Case
<expression
[<statement>] ...
Break
[Default]
[<statement>] ...
SwitchEnd
<expression 1> through <expression
numbers.
Function: This command executes one of a series of processes based on the value of
<expression>.
De cription
• This command executes the statement following the Ca e expression that matches the
Switch expression.
• If there is no matching Ca e expression, the statement following Default is executed. If
there is no Default specified, a non-match jumps to the statement following SwitchEnd.
• You can use a multi-statement command (:) in place of the carriage return to separate
statements.
• Switch~SwitchEnd can be exited using the Break command, Return command, or Goto
command.
Wait
Syntax:
Wait
[<expression>]
Function: This command pauses program execution, and then restarts it after the number of
seconds specified by the expression passes.
De cription
• If you do not specify any expression, program execution is paused until you tap the screen,
or press a key.
• The maximum valid specification for <expression> is 360 seconds (six minutes). Specifying
a value greater than 360 causes program execution to resume after 360 seconds,
regardless of the specified value.
• The ClassPad's Auto Power Off function is disabled during a pause caused by the Wait
command.
• If the Auto Power Off trigger time is reached during the pause, program execution resumes.
12-6-14
Program Command Reference
n
>
n
> should be expressions that produce real
20060301
Advertisement
Table of Contents
