Troubleshooting - Microtek FileScan 3125c User Manual

Troubleshooting

The LED on the scanner cover indicates the status of the scanner.
First, make sure that you have followed Steps 1 to 4 as described in the "Initial
Setup" section of this document (unpack, install, connect). Then if your problem
is listed here, try the suggested solution.
1. No light comes on when the scanner is already supplied with power.
2. The Add/Remove Hardware Wizard appears on your screen.
3. When trying to scan, an error message appears on your screen that reads,
4. Ink stains or strips appear on the scanned images.
5. After clicking scan, a blank screen appears.
6. When trying to scan, an error message appears on your screen that reads,
44 FileScan 3125c User's Manual
Green On: Ready to scan.
Flashing Green: Scanning.
Flashing On: Scanning errors happens.
Off: Scanner is off.
Make sure your scanner is connected to your computer and plugged into a
power source.
Click the "Cancel" button and close the ScanWizard DI Control Panel.
Disconnect the Hi-Speed USB cable from the back of your computer, and
refer to the installation instructions in this document.
"Can't Find Scanners".
Make sure your scanner is connected to your computer and plugged in to a
power source (see Step 4 in the "Initial Setup" section).
Uninstall and reinstall the ScanWizard DI software.
Clean the glass surface areas with a soft, non-abrasive and lint-free cloth.
Clean the rollers with a lint-free cloth or a swab moistened with alcohol or
ECO cleaner
Uninstall and reinstall the ScanWizard DI software.
"ADF is not ready or no paper".
Make sure there are papers on the Document Feed Tray.
Make sure the top edges of papers have been inserted into the feeder.
LED