Features And Controls; Operation - Briggs & Stratton 1696715-00 Operator's Manual

Features and Controls

Compare the callout letters (Figure 2) to the features and
controls shown in the table below.
2
Control Symbols and Meanings
A Auger control
B — — — Auger
C Chute Control - Lever Operated
D Chute Control - Handle Operated
E Chute Control - Switch Operated
F Chute Control - Crank Operated
G Deflector Control -Trigger
H Starter Button
I Starter Receptacle
J — — — Starting Instructions Decal (if equipped)
K — — — Starting Instructions Decal (if equipped)
L — — — Headlight (if equipped)
M Choke CLOSED/OPEN
N — — — Fuel Tank Cap
O — — — Oil Fill/Dipstick
P Primer Button
Q Ignition Switch
R — — — Starter Cord Handle
S — — — Oil Drain Plug

Operation

WARNING
This snowthrower is only as safe as the operator. If it is
misused, or not maintained correctly, it can be dangerous.
Remember you are responsible for your safety and those
around you.
• When leaving the operating position always disengage
the auger, STOP the engine, and remove the key. DO
NOT leave a running machine unattended.
• DO NOT operate the snowthrower without the correct
guards, and other safety protective devices in place and
working.
• Be careful when you operate the unit on gravel
driveways, walkways, or roads. Stay alert for hidden
hazards or traffic.
• DO NOT operate the snowthrower without good
visibility or light. Always be sure of your footing, and
keep a firm hold on the handles. Walk; never run.
• Be careful to avoid slipping or falling, especially when
you operate the snowthrower in reverse.
• Be careful when you operate the snowthrower on
slopes.
• If you strike a foreign object, stop the engine, remove
the wire from the spark plug, thoroughly inspect the
snowthrower for damage, and repair the damage before
you start and operate the snowthrower.
• DO NOT operate the equipment without wearing
adequate winter garments. Avoid loose fitting clothing
that can get caught in moving parts. Wear footwear that
will improve footing on slippery surfaces.
• DO NOT touch a hot muffler or engine. Let the muffler
and engine cylinder to cool before touching.
Operating Area
1. Identify the walkways and driveways where you plan to
operate the snowthrower.
2. Make sure that the area is free of debris or objects that
the auger could pick-up and throw from the chute.
5