Emerson Micro Motion 1600 Installation Manual page 30

Set up the printer
March 2022
6. Change the PC network settings back to the original settings.
7. Configure the 1600 Ethernet transmitter for the printer.
30
b) Select ADVANCED.
c) Select Proceed to 192.168.192.168.
d) At the login screen, enter:
Default username: epson
Default password: epson
The EpsonNet Config utility screen displays.
e) Select TCP/IP under the configuration settings (not the basic settings), listed
on the left side of the screen.
f) Change the IP Address (i.e., 192.168.1.55), Subnet Mask, and Default
Gateway based on your network. Select an IP address that is unique to the
local network.
The printer must be on the same subnet as the 1600.
g) Required: Set Acquiring the IP Address to Manual.
h) Select Send to save your settings.
i) Select Reset, or power cycle the printer when prompted to apply the
changes.
Use the windows you used in
a) Remove the Ethernet cable from the PC and connect it to the 1600 Ethernet
transmitter.
b) If you have not already done so, configure the transmitter IP address, subnet
mask, and default gateway.
Display
ProLink III
For instructions on how to configure the transmitter and PC Ethernet
settings, see the Micro Motion 1600 with Ethernet Transmitters: Configuration
and Use Manual.
c) Enter the printer IP address you configured in the previous step into the 1600
Ethernet transmitter.
Display
ProLink III
Web browser
Step 4.
Menu → Configuration → Ethernet Settings →
Network Settings
Device Tools → Configuration → Network Settings
Menu → Configuration → Printer → Printer IP
address
Device Tools → Configuration → Printer and Tickets
Configuration → Printer and Tickets
Micro Motion 1600 Ethernet Transmitters
Installation Manual
00825-0100-1600