Advertisement
CY22 Moterra Neo
LockR Axle
Be sure to support the bike or swingarm to prevent personal injury or bike damage when removing/
disconnecting linkages of an axle.
To remove the LockR :
1.
Loosen the screw 4-6 turns using a T25 Torx key.
2. Tap head of screw with a rubber mallet to un-seat the wedge bolt located on the opposite side.
3. Remove the screw and wedge bolt from the still-installed axle.
4. If the axle did not come out with the screw, insert a 5 mm hex key and turn to free and remove
it. If the wedge still sticks, insert a wooden or plastic dowel into the drive side and drive it out.
5. To remove the axle, insert a 6 mm hex key on the non-drive side and turn counter-clockwise
until it can be removed.
To install the LockR:
1.
Disassemble and clean all parts of the LockR axle. Do not install it assembled.
Inspect the parts for damage (e.g., burrs, scratches, deformity, and wear). Replace the entire
LockR assembly if any damage is found.
2. Apply a light coating of a high-quality bicycle bearing grease to all parts.
3. Align the linkage and bearing and insert the threaded end of the pivot axle (1) into the non-drive
side.
4. Tighten the inserted pivot axle to 1 N·m using a 6 mm hex key fitted torque wrench from the
non-drive side.
NOTICE
Use a calibrated torque wrench.
Exceeding 1 N·m will result in permanent damage to the LockR pivot system.
138688 Rev 1 (04/22)
30
Technical Information
LockR Axle
Advertisement
