Advertisement
Cables Sleeve & Anti-Wear Wrap - Carbon
Identification
1.
Sleeve (sized)
2. Sleeve (un-sized)
3. Trim lines
Sleeve (1)
The sleeve (1) and placement of nylon anti-wear
wrap (8) is required on carbon frames.
The sleeve placed over the fork steerer prevents
direct cable contact with a moving steerer.
The cable sleeve must be sized to the correct
height depending on the headtube length. The
cable sleeve height should be within 10-25mm of
the bottom of the upper headtube bearing as
shown.
10-25mm
4. Fork steerer
5. Upper bearing
6. Lower bearing
Anti-wear wrap (8)
In addition to the sleeve, the cables between the
lower Acros headset spacer and the first cable
clamp in the downtube must be fitted with nylon
anti-wear wrap.
See WARNING on next page.
19
Technical Information
Cables Sleeve & Anti-Wear Wrap - Carbon
7. Internal cables
8. Nylon anti-wear wrap
9. Acros Lower headset part
Advertisement
