Advertisement
CY22 Moterra Neo
Downtube Battery
The drive system battery (3) is housed within
the bicycle downtube. The battery can be
removed for charging or charged via the
battery charge port. See page 21.
To remove the battery:
1.
Secure the bike upright to prevent it from
falling over.
2. Make sure the bike drive system is OFF.
3. Turn the battery cover knob (2) counter-
clockwise to release the battery cover (1)
from the frame.
4. Remove the key cover (8) and insert the
key (7) into the key slot.
Turn the key clockwise to permit the
release of the battery.
5. Allow the top of the battery to move
forward. Press the safety catch button (5)
and lift the battery out of the frame.
To install the battery:
1.
Secure the bike upright to prevent it from
falling over.
2. Turn the key clockwise to release the
battery frame latch.
3. Insert the lower parts of the battery so
that the battery socket engages with the
frame connector (4).
138688 Rev 1 (04/22)
4. Press in on the top of the battery causing
the ramp and lock to engage fully.
5. Remove the key.
6. Install the battery cover (1) and secure it
with the cover knob (2).
NOTICE
Do not ride the bike without the battery
cover installed. Dirt, water, and other
contaminants can enter the frame and/or
damage the battery.
Periodically, check to make sure the battery
is securely mounted inside the frame and
the cover is closed securely.
Check the battery after any fall or impact.
Check for loose or damaged parts.
If you take the battery out, replace and
secure the battery cover on the frame.
If damage is found, do not ride the bike.
Have any damaged part replaced with a
new one.
26
Technical Information
Downtube Battery
Advertisement
