Advertisement
CY22 Moterra Neo
Yoke / Shock Eyelet
Identification
1.
Bolt (female)
2. Bolt (male)
The following is standard maintenance and
should be repeated as often as necessary to
ensure a quiet bike:
1.
Disconnect the rear shock from the yoke and
clean the yoke bolts, eyelet, and the shock
eyelet surfaces with isopropyl alcohol and a
clean shop towel.
2. Apply anti-seize thread lubricant (Perma-
tex®) to all contact surfaces including the
inside chamfer on the yoke bolts. Do not use
grease - grease does not perform as well as
anti-seize.
138688 Rev 1 (04/22)
3. Spacers (2X)
2
Loctite 242 (blue)
15 N·m
a.
Spacer tab
3. Clean the smaller (male) yoke bolt and apply
a 3 mm-wide band of Loctite 242 (blue) at
the first few threads.
4. Make sure the spacers are located betwen
the yoke and the shock eylet. Notice that the
spacer tabs are positioned to the front and on
the yoke as pictured above.
5. Tighten to 15 N-m. Hold the large (female)
yoke bolt with an inserted hex key and
tighten the smaller (male) yoke bolt.
28
Technical Information
Yoke / Shock Eyelet
Advertisement
