Hioki MEMORY HiCORDER MR6000 Instruction Manual page 151

(4) Tap the [Comparison bit]
X
Ignores a signal.
The CAN-trigger condition for each CAN signal is satisfied when the signal is at a low
0
level.
The CAN-trigger condition for each CAN signal is satisfied when the signal is at a high
1
level.
The CAN-trigger conditions are defined, as with the logic-trigger conditions, depending on the
combination of the condition setting of satisfaction and the trigger pattern setting.
See "5.7 Triggering the Instrument Using Logic Signals (Logic Trigger)" (p. 138).
You can monitor CAN bus states by tapping
See "Monitor the state of the CAN/LIN bus." (p. 289).
Triggering the Instrument Using CAN Signals (CAN Trigger)
box, and then set the CAN-trigger pattern.
[START] on the CAN trigger setting screen.
HIOKI MR6000A966-03
145