Table of Contents
Advertisement
7.1 Support removal
The after-processing guide is the standard guide of remov-
ing FFMS3100 support. Please prepare some The actual
results may be somewhat different from the following
process. Please prepare the items in the next column before
the procedure. Also, make sure that the room where the
execution is performed is well ventilated or that the ventila-
tion cover is placed.
· Magnetic agitators
· Isopropanol
· The protective mirror
1. Place the build plate on the heated platform of the magnet-
ic agitator. Remove the model one by one when the support
material is softened.
Note: there are a lot of thin printed objects on the
build plate, please start heating from the all around to
the center and remove the model carefully.
Note: please twear protective mirrors, dust masks and
rubber gloves before removing the support.
2. Pre-configure three dissolved solvents.
Dissolved solvent 1, which be used first and to wash 90%
support wax.
(Ingredient，PPG400*1，alcohol*2，isopropanol*2, The
pre-prepared solvent should be shaken well before use.)
Dissolved solvent II, used second to wash the remaining
support wax in detail.
(Ingredient，PPG400*1，alcohol*3，isopropanol*3. The
pre-prepared solvent should be shaken and mixed before use)
Dissolved solvent III, which be used to clean the remaining
solvent.
（Ingredient，PPG400*1，alcohol*3，isopropanol*3)
Chapter 7 After-processing Guide
· Beaker
· The net basket
· PPG400
· Waterless ethanol
· Dust masks
· rubber gloves
3. Put the beaker and other containers on the magnetic stirrer;
add dissolved solvent I and turn on the heating to keep the
temperature at 40 ℃; the temperature shall not exceed 43 ℃.
33
Advertisement
Chapters
Table of Contents
