Important Safety Information - Flashforge Waxjet 400 User Manual

Important Safety Information

Please make sure to read the following Safety guidelines carefully
Safety Symbols and Definitions
Hot surface danger:
There is a hot surface around this sign or behind
the access port. Avoid touch. Hot surfaces can
cause burns or fire. Make the surface cool down
before touching. The access port is for mainte-
nance only, It can be opened only certified
service personnel or well-trained maintenance
personnel.
Keep fingers away from sharp objects:
Putting your fingers in front of sharp objects may
cause serious injury.
Wear gloves:
Please wear suitable gloves as needed. wear
heat-resistant gloves when contacting hot
surfaces to avoid burns.
Wear glasses:
In the case of possible leakage or splashing of
structural materials, protective glasses with side
shields should be worn to protect the eyes.
Risk of electric shock:
There will be high voltage near this sign or
behind the access port. High Voltage Association
causes severe burns or death, or fire.The access
port is for maintenance only, It can be opened
only certified service personnel or well-trained
maintenance personnel.
Hand involvement warning:
There is a danger of gears or moving parts near
this sign or behind the access port. The access
port is for maintenance only, It can be opened
only certified service personnel or well-trained
maintenance personnel.
Note:
Used to prompt important information rather
than critical information.
Improper use of the 3D printer system can cause personal
injury.
When operating the machine, please follow the following
safety guidelines:
Read and follow all 3D printer system instructions. The
printer should only be operated by professionals.
Please follow all safety rules and pay attention to all
precautions in this guide and warning.
Do not try to open the top cover during printing.
Do not use any materials before viewing the globally
harmonized standard/safety data sheet (GHS/SDS).
Do not attempt to use, repair or adjust before viewing the
user's routine maintenance program documentation,
except for trained professionals.
Only certified maintenance personnel who have completed
FlashForge maintenance training can perform tasks that
are authorized and certified to allow the above personnel
to complete.
Do not ignore the warning signs issued during the mainte-
nance operation of the 3D printer system. If an error
message is displayed on the user interface of the 3D printer
system, please refer to the "Troubleshooting " in this guide
before resuming operation.
03
General