Camera Connection; Model Removal After Finishing Printing - Flashforge Guider 3 Plus User Manual

1. Please remove the camera cover before using the camera;
2. Turn on the camera switch;
3. After the equipment is connected to FlashPrint, the real-time video and image can
be viewed in the FlashPrint - [Multi-Machine Control].

4.5 Model Removal After Finishing Printing

WARNING
After finishing printing, horizontally pull the two lock latches on the front of the
platform plate outward for 180 degrees, take out the whole platform plate, and bend
the platform plate to remove the model.
Remove the model and put the platform plate
back into the equipment. Operate as follows:
1. Install the flexible steel plate on the platform
plate with the four snap hooks inserted
at the rear end (note that the
inside of the snap hooks
should be inserted);
2. Rotate the lock latch until
it presses against the flexible
steel plate.

4.4 Camera Connection

When removing the model from the build plate, please pay attention
to the need to wait for the platform to cool down before operating.
At this time, you can check the temperature icon on the status bar of
the screen to confirm the platform temperature. The green icon
indicates that the platform temperature is lower than 50℃, which is
the appropriate state for safe operation. The matching gloves should
be used when removing the model. In the meanwhile, pay careful
attention to the high temperature of the equipment.
Locking
Unlocking
14