Trace Key - Janome Continental M17 Instruction Book

q
1.
w
2.
e
3.
r

Trace key

You can check the size of the embroidery area by tracing
the pattern outline without stitching or with basting
stitches.
Press the trace key and the trace option window will
open.
q Trace key
NOTE:
• The machine will baste around the embroidery area
with a 5 mm allowance. However, the allowance will
be null if the pattern spreads over the maximum limit
of embroidery area.
• Lower the presser foot if the presser foot is raised
with the presser foot lifter when tracing and basting.
• It is recommended to bring up the bobbin thread
before pressing the start/stop button (refer to
page 30).
The following 4 options are available:
1. Trace without stitching
Press the key w to open the trace without stitching
window.
Press the trace key
keys to move the hoop to a corner.
2. Trace and baste (single)
Press the key e to open the trace and baste (single)
window.
Press the start/stop button to start tracing with basting
stitches.
3. Trace and baste (double)
Press the key r to open the trace and baste (double)
window.
Press the start/stop button to start tracing with basting
stitches. First, the machine bastes inside the pattern then
traces the pattern outline with basting stitches.
51
to start tracing or press one of the