Lace Design Sq28D #164; (Designs For Water Soluble Stabilizer) - Janome Continental M17 Instruction Book

z
x
c
v
b
Lace design SQ28d #164 (Designs for water soluble
stabilizer)
You can attach up to 4 flower designs to the large lace
design (Designs for water soluble stabilizer) SQ28d #164.
z Prepare the flower designs you want to attach before
sewing lace design SQ28d #164.
Select the desired flower designs from the "Designs
for water soluble stabilizer" category, and sew them to
the water soluble stabilizer.
Remove the water stabilizer by soaking the flower
designs in a bowl of warm water.
Be sure that the lace piece to be attached is
completely dried out after removing from water.
NOTE:
• Do not rub or scratch the Designs for water soluble
stabilizer.
• Refer to page 37 for how to use a water soluble
stabilizer.
x Draw centerlines on the water soluble stabilizer with
tailor's chalk. Set the water soluble stabilizer in hoop
SQ28d and attach the hoop to the carriage.
NOTE:
Do not use water soluble tailor's chalk.
The water soluble stabilizer will be washed away.
c Select the SQ28d #164 design (Designs for water
soluble stabilizer).
v Sew until the 11th section (color). The 11th section is
the placement guide for placing flower designs.
Place one of the flower design pieces which was
created in step z above so that the flower design is
aligned with the placement guide.
b Use tape to hold the design for your convenience.
Sew the 12th section (color) over the design. The
flower design is attached to the large lace SQ28d
#164 design.
68