Janome Continental M17 Instruction Book page 79

.
r
e
⁄0
⁄1 ⁄2
!2
!1
!1
!2
. Hold the yarn with both hands.
Slide the yarn under the plate, and slip it into the
presser foot hole.
Draw the yarn and needle thread to the rear.
e Presser foot hole
r Plate
!1 Yarn
!2 Needle thread
CAUTION:
Knots may appear at some points of a ball of yarn.
Be careful not to feed the knot of yarn into the mouth
of the yarn guide while sewing.
⁄0 Set the fabric to the hoop.
Attach the hoop to the carriage.
Test sew to check sewing results before the actual
sewing.
⁄1 Press the start/stop button and sew 5 to 6 stitches.
Press the start/stop button again to stop the machine.
⁄2 Cut the loose yarn and needle thread near to the
starting point.
Press the start/stop button to start sewing again.
The machine will stop (and trim the threads if the auto
thread cutting is activated) automatically when the first
color section is finished.
!1 Yarn
!2 Needle thread
⁄3 Change the thread to the next color and yarn.
Sew the next section.
NOTE:
• Remove the couching foot when the couching design
is finished. The needle may strike the couching foot
when switching to ordinary sewing mode.
• Select embroidery foot P in the embroidery select
window when you replace the presser foot with
embroidery foot P (refer to page 54).
• When you combine couching designs, it is necessary
to stop the machine and trim the excess yarn after
the yarn jumps to the next couching design.
75