Janome Continental M17 Instruction Book page 107

!5
!6
!7
!8
NOTE:
You do not need to change Locking stitch function
settings when using built-in embroidery designs.
!5 Locking Stitch ON/OFF (after Each Color Change)
The threads may ravel if the stitch data does not contain
locking stitches at the beginning of each color section.
To avoid raveling, insert locking stitches at the beginning
when this function is turned ON.
- 1
!8
!6 Locking Stitch ON/OFF (after Thread Trimming)
If you turn ON thread cutting (refer to the previous page
"Thread cutting"), the machine will insert locking stitches
after the jump to avoid threads from raveling.
!7 Design Positioning During Embroidery
If you turn ON the "Design Positioning During Embroidery",
you can re-position the embroidery design with the jog
key.
!8 Hoop Calibration
You can calibrate the center position of the hoops.
You need to enter embroidery mode before opening the
embroidery setting window.
Attach the embroidery unit and press the
The carriage moves to the center position.
Select the hoop and attach it to the carriage. Set the
template in the hoop.
- 2
!8
Adjust the hoop position by pressing the jog keys so that
the needle is right above the hole in the template and
press the OK key.
- 2 Jog keys
!8
Press the next page key to go to the next menu.
103
key - 1.
!8