Janome Continental M17 Instruction Book page 29

e
c
w
x
v
r
t
b
n
y
m
,
.
z
q
u
i
!0
Winding the bobbin
NOTE:
You can adjust the bobbin winding speed (refer to
page 99).
z Raise the thread guide bar until it snaps.
Pass the thread through the guide on the thread guide
bar from behind.
q Thread guide bar
x Pass the thread under the right thread guide.
w Right thread guide
c Pass the thread under the bobbin winding tension
disk.
e Bobbin winding tension disk
v Put the bobbin on the bobbin winder spindle.
r Bobbin
t Bobbin winder spindle
b Pass the thread to the bobbin.
Hold the thread with both hands and wind it around
the bobbin clockwise several times.
n Insert the thread into one of the slits of the flange
plate and pull the thread to cut.
y Slit
u Flange plate
m Push the bobbin winder stopper to the left.
i Bobbin winder stopper
, Press the bobbin winding button. The right touch
o
screen will show the bobbin winding sign.
o Bobbin winding button
When the bobbin is fully wound, it will stop spinning
and the bobbin stopper returns to its original position
automatically.
. Remove the bobbin. Cut the thread with the thread
cutter (rightmost).
!0 Thread cutter (rightmost)
NOTE:
For safety purposes, the machine will automatically
stop 1.5 minutes after starting bobbin winding.
25