Table of Contents
Advertisement
The compressor name plate is positioned on the compressor and contains this information:
Compressor no.
Year
Type
Refrigerant
Speed
Swept volume
Pressure system
Allowable pressure, max.
Test pressure
CE and Ex
EAC
Identification no. (serial no).
Year of manufacturing.
Manufacturer's type designation.
Allowable refrigerant or refrigerants for the compressor.
(The actual refrigerant for the unit is stated on the unit name
plate).
Specific rotational speed. Specific rotational speed is used for cal-
culating swept volume. For the actual allowed operating speed,
please refer to the operating limits and Matchmaster's calculation
on the actual operating condition.
Swept volume of the compressor at nominal speed.
The low-pressure side of the compressor is referred to as the LP
side.
The high-pressure side of the compressor is referred to as the HP
side.
The max. pressure (pressure relative to atmospheric pressure)
that the compressor has been designed for in terms of pressure
strength design.
The maximum practical operation pressure is lower than the maxi-
mum allowable pressure, depending on the operating conditions
and safety equipment settings.
The test pressure the compressor has been strength tested with.
The CE and Ex marks indicate that the compressor has been de-
signed in accordance with the EC ATEX directive.
The EurAsian Conformity mark (EAC) indicates that the compres-
sor is in compliance with all relevant technical regulations of the
Eurasian Customs Union.
16/56
Safety
Operating manual - ComPAC
011769 en 2020.03
Advertisement
Table of Contents
