Table of Contents
Advertisement
1. Introduction
1.1
Introduction to the manual
This manual describes operating conditions for the unit, including:
•
Dangers resulting from failure to comply with safety precautions when operating the
equipment and performing maintenance tasks.
•
How to start, operate and stop the equipment safely.
•
How to act when problems occur during operation.
•
Scheduled maintenance tasks for the equipment and when/how to carry them out safely.
This manual is primarily intended for operators and engineers.
To prevent accidents, assembly and disassembly of components should be carried out by compe-
tent personnel only.
•
It is important that the operating personnel familiarise themselves with the contents of
this manual in order to ensure a proper and efficient operation. Johnson Controls Den-
mark is not liable for damage occurring during the warranty period where this is attribut-
able to incorrect operation.
•
All compressor intervention within the warranty period must be performed by competent
personnel only. If not, the warranty no longer applies.
For further information, see www.sabroe.com
This manual is produced by:
Johnson Controls Denmark ApS
Christian X's Vej 201
8270 Højbjerg, Denmark
Phone +45 87 36 70 00
CVR No 19 05 61 71
www.sabroe.com
Copyright © Johnson Controls Denmark
This manual must not be copied without the written permission of Johnson Controls Denmark and
the contents must not be imparted to a third party nor be used for any unauthorised purposes.
Contravention will be prosecuted.
8/56
Introduction
Operating manual - ComPAC
011769 en 2020.03
Advertisement
Table of Contents
