Table of Contents
Advertisement
1-1. Overview of SW24GF
SW24GF, a 24-port Gigabit L2 Plus Managed Switch, is a standard switch
that meets all IEEE 802.3/u/x/z Gigabit, Fast Ethernet specifications. 16-Port
1000Mbps SFP and 8-Port Combo Gigabit TP/SFP Fiber dual media management
Ethernet switch. The switch can be managed through RS-232 serial port via directly
connection, or through Ethernet port using CLI or Web-based management unit,
associated with SNMP agent. With the SNMP agent, the network administrator can
logon the switch to monitor, configure and control each port's activity in a friendly
way. The overall network management is enhanced and the network efficiency is
also improved to accommodate high bandwidth applications. In addition, the switch
features comprehensive and useful functions such as QoS (Quality of Service),
Spanning Tree, VLAN, Port Trunking, Bandwidth Control, Port Security,
SNMP/RMON, IGMP Snooping capability via the intelligent software. It is suitable
for both metro-LAN and office applications.
Others the switch increase support the Power saving for reduce the power
consumption with "ActiPHY Power Management" and "Perfect Reach Power
Management" two technique. It could efficient saving the switch power with auto
detect the client idle and cable length to provide different power.
In this switch, Port 1 and Port 8 include two types of media --- TP and SFP
Fiber (LC, BiDi LC...); this port supports 10/100/1000Mbps TP or 1000Mbps SFP
Fiber with auto-detected function. 1000Mbps SFP Fiber transceiver is used for high-
speed connection expansion.
⎯
1000Mbps LC, Multi-Mode, SFP Fiber transceiver
⎯
1000Mbps LC, 10km, SFP Fiber transceiver
⎯
1000Mbps LC, 30km, SFP Fiber transceiver
⎯
1000Mbps LC, 50km, SFP Fiber transceiver
⎯
1000Mbps BiDi LC, 20km, 1550nm SFP Fiber WDM transceiver
⎯
1000Mbps BiDi LC, 20km, 1310nm SFP Fiber WDM transceiver
10/100/1000Mbps TP is a standard Ethernet port that meets all IEEE
802.3/u/x/z Gigabit, Fast Ethernet specifications. 1000Mbps SFP Fiber transceiver
is a Gigabit Ethernet port that fully complies with all IEEE 802.3z and 1000Base-
SX/LX standards.
1000Mbps Single Fiber WDM (BiDi) transceiver is designed with an optic
Wavelength Division Multiplexing (WDM) technology that transports bi-directional
full duplex signal over a single fiber simultaneously.
For upgrading firmware, please refer to the Section 3-21 or Section 4-2-2 for
more details. The switch will not stop operating while upgrading firmware and after
that, the configuration keeps unchanged.
Note:
The switch was for using indoor purpose, if it was used in outdoor
environment or connect with cable to outdoor then it must to use a
lightning arrester to protect the switch.
1. Introduction
6
Advertisement
Table of Contents
