Table of Contents
Advertisement
MAINTENANCE
If the fuse is blown, check the
cause, then replace the fuse with a
spare fuse of the same rated
capacity. Unless the cause is found,
the fuse may blow again.
Main Fuse
<Replacement>
A spare fuse is located on the reverse
side of the junction box lid.
1. Stop the engine.
2. Remove the engine cover.
3. Remove the junction box lid and
pull the old fuse out of the clip with
the fuse puller supplied in the fuse
holder.
4. Push a new fuse into the clips.
5. Reinstall the junction box lid, and
the engine cover.
6. Reconnect the battery.
DESIGNATED FUSE:
7.5 A, 10 A, 15 A, 30 A
138
Mechanical wire type
Fuse No.
Rating
1
100 A
ACG, Battery
4
30 A
STARTER SOLENOID, AND RELAYS IN JUNCTION BOX
5
10 A
Power tilt relay, Warning buzzer, Indicator, Meter
8
10 A
Fuel pump (High pressure side)
9
15 A
Injector, ECU
10
10 A
DLC, Fuel pump (Low pressure side)
11
15 A
PTC
3 A
Battery switch OFF notification
DBW type
Fuse No.
Rating
1
100 A
ACG, Battery
2
15 A
GROUND
3
7.5 A
12 V Accessory
4
30 A
STARTER SOLENOID, AND RELAYS IN JUNCTION BOX
5
7.5 A
REMOTE CONTROL SYSTEM
6
30 A
SHIFT ACTUATOR
7
15 A
THROTTLE BODY
8
10 A
Fuel pump (High pressure side)
9
15 A
Injector, ECU
10
10 A
DLC, Fuel pump (Low pressure side)
11
15 A
PTC
3 A
Battery switch OFF notification
Component(s) or Circuit(s) Protected
Component(s) or Circuit(s) Protected
Advertisement
Table of Contents
