Moorage - HONDA marine BF115J Owner's Manual

Moorage

Tilt up the outboard motor using the
tilt lock lever when mooring the boat.
Shift the remote control lever into the
NEUTRAL position and stop the
engine before tilting up the outboard
motor.
Before tilting up, leave the outboard
motor in the running position for one
minute after stopping the engine to
drain the water from inside the
engine.
TILT LOCK LEVER
FREE
LOCK
STERN BRACKET
Stop the engine and disconnect the
fuel line from the outboard motor
before tilting the outboard motor.
1. Raise the outboard motor as full as
it goes using the power trim/tilt
switch.
2. Move the tilt lock lever to the
LOCK position and lower the
outboard motor until the lock lever
contacts the stern bracket.
3. Press the DN (down) of the power
trim/tilt switch and fully shorten
the trim rods.
OPERATION
4. To tilt down, raise the outboard
motor as far as it goes using the
power trim/tilt switch, move the tilt
lock lever to the FREE position,
and lower the outboard motor to
the designated position.
TRIM ROD
101