(R2, R3 Types) - HONDA marine BF115J Owner's Manual

STARTING THE ENGINE
• If the engine is not properly
warmed-up before raising the
engine speed, the warning buzzer
and overheat indicator may
activate and the engine speed will
be automatically reduced.
• The cooling system may freeze in
areas where the temperature
reaches 0°C (32°F) or below.
Cruising at high speed without
warming the engine up may
cause engine damage.
Before leaving the dock, check the
operation of the emergency stop
switch.

(R2, R3 types)

WARNING
Exhaust contains poisonous
carbon monoxide which can
cause unconsciousness and may
lead to death. Never run the
outboard motor in a boat house or
other confined area.
78
To prevent damage to the outboard
from overheating, never run the
engine with the propeller out of water.
EMERGENCY SWITCH PANEL
STOP SWITCH
EMERGENCY STOP
SWITCH LANYARD
EMERGENCY STOP
SWITCH CLIP
When the boat is mounted with the
two outboard motors, perform the
following on the right and left
engines respectively.
1. Insert the clip at one end of the
emergency stop switch lanyard into
the emergency stop switch. Attach
the other end of the emergency stop
switch lanyard securely to the
STOP
operator.
Be sure to install the emergency
stop switch clip to the emergency
stop switch on the remote control
box as well as on the switch panel.
If the operator does not attach the
emergency stop switch lanyard,
and is thrown from the seat or out
of the boat, the out-of-control
boat can seriously injure the
operator, passengers, or
bystanders. Always properly
attach the lanyard before starting
the engine.
WARNING