Table of Contents
Advertisement
3.2.4 — UNCOUPLE THE CYLINDER
3.2.5 — SPECIFIC TO QLIXBI SMART CONNECTORS
(S230 and S300 models)
10 | Qlixbi User Manual
After closing the lever and allowing the regulator to purge the gas
through connected equipment such as welding torches (refer to the
regulator user manual), turn the regulator off, unclip the Qlixbi connector
vertically by pinching the unlocking ring and cover. (During this step, the
Qlixbi connector is purged automatically).
Important Note
During the uncoupling process a noise due to the gas purge
may occur. This noise is normal and will cease when the
connector is released.
Tips
When the cylinder pressure is above 250 bar, it may be
more difficult to uncouple the connector of the cylinder due
to the purge. To make this operation easier, it is advised to
purge the connector through the welding machine and/
or the welding torch. In case of difficulties, refer to the
troubleshooting section.
• The disconnection is only possible when the purge process is
completed.
Warning
• During this step the weight of the regulator might topple
the connector over when disconnecting - Be sure to hold
the connector and the regulator.
• In any case, never apply excessive force on the connector
to uncouple it from the cylinder.
• No need to unscrew the regulator, the Qlixbi connector can be kept with
the regulator fixed.
• The Qlixbi connector must be kept in a dry place and protected from dust.
• Replace the cover cap of the cylinder on the reserve indicator after usage.
When the On/Off Lever is lifted, the led indicator flashes after a
few seconds.
LED glows green when your Qlixbi is online and ready to transmit data.
LED glows red when the data transmission doesn't work.
Please refer to the troubleshooting section or contact your Energas
customer support.
Advertisement
Table of Contents
