Brother MFC-J3540DW Online User's Manual page 42

Home > Paper Handling
or Legal Size Paper in Paper Tray #1 / Paper Tray #2
Load A3, Ledger, or Legal Size Paper in Paper Tray #1 / Paper Tray #2
• If the [Check Paper] setting is set to [On] and you pull the paper tray out of the machine, a message
appears on the LCD, allowing you to change the paper size and paper type.
• When you load a different paper size in the tray, you must change the Paper Size setting in the machine or
the paper size setting on your computer.
Doing this enables the machine to automatically feed paper from the appropriate tray if Auto Tray Select
has been set in the printer driver (Windows) or on the machine. (MFC-J3940DW)
• You can use only plain paper in Tray #2. (MFC-J3940DW)
These instructions describe how to load paper in Tray #1.
• (MFC-J3940DW) The steps for Tray #2 are very similar.
1. If the paper support flap (1) is open, close it, and then close the paper support (2).
2
2. Pull the paper tray completely out of the machine as shown by the arrow.
(MFC-J3940DW)
When you load paper in Tray #2, remove the tray top cover (1).
3. Rest the tray on a flat surface.
Push the green slider to the left and then extend the tray until it locks into place.
> Load Paper > Load Paper in Paper Tray #1 / Paper Tray #2
1
1
> Load A3, Ledger,
35