Evolution R185SMS-Li Original Instructions Manual page 18

Fig. 18
Fig. 19
Fig. 20a
Fig. 20b
• Press the black arbor lock button to lock the arbor. (Fig. 18)
• Using the supplied Hex Key, release the flange bolt and
outer blade flange and the blade from the arbor. (Fig. 19)
Note: The arbor screw has a LH thread.
Turn clockwise to loosen. Turn counter clockwise to tighten.
Ensure that the blade and blade flanges are clean and free
from any contamination.
• The inner blade flange should be left in place, but if it is
removed for cleaning it must be replaced the same way
round as it was removed from the machine.
WARNING: To safely install Evolution Multi-material blades
the inner blade flange must be installed with the 25.4mm
boss facing to the outside. (Fig. 20a)
Install the new blade. Make sure the rotation arrow on the
blade matches the clockwise rotation arrow on the upper
guard.
Note: The blade teeth should always point downward at the
front of the saw.
• Install the outer blade flange and flange bolt. (Fig. 20b)
• Lock the arbor and tighten the arbor screw using moderate
force, but do not overtighten.
• Ensure the Hex Key is removed and the arbor lock has
released before proceeding.
• Ensure the blade guard is fully functional before using the
machine.
18
www.evolutionpowertools.com