Set Factory Defaults; Led Test - Hanskamp Spider Installation And Operating Instructions Manual

EN
Feeding computer - Voercomputer - Fütterungscomputer - Logiciel d'alimentation
from Antenna
Result of the tag detection is shown below.
If no tag is found, this will be reported and the old settings will be restored. You can then manually try to read the tag by
changing the SpiderPCB parameters. See chapter 4.3.4 on how to change SpiderPCB parameters.

4.3.2 Set factory defaults

Reset all parameters to default.

4.3.3 LED test

All external LEDs on the Spider unit will be activated.
Index
Hanskamp AgroTech B.V. (The Netherlands)
25 - 46
www.hanskamp.nl/en
Spider