Table of Contents
Advertisement
EN
Feeding computer - Voercomputer - Fütterungscomputer - Logiciel d'alimentation
4.3 SpiderPCB parameters (transponder configurations)
To change the settings of the SpiderPCB (e.g. settings of transponders and Antennas), go to 'Parameters'.
-
Go to 'Maintenance' and sign in as administrator.
-
Go to 'Settings'
'Configuration SpiderPCB' and select tab 'Parameters'.
->
The below screen will open:
The submenus and installation process are explained below.
4.3.1 Tag tuning
Tag tuning is used for automatic programming of the SpiderPCB's RFID settings; every SpiderPCB must be configured
separately. With tag tuning, all transponder settings are set correctly, and all connected Antennas are properly
adjusted. (See chapter 5 for FloorAntenna.)
Configuring the transponder:
−
If the old (120 kHz) responder by Nedap is used, move
the jumper on the SpiderPCB to N old (see image on
the right).
−
Place any transponder used by this customer on the
first connected Antenna.
−
Click on 'Tag tuning' and then on 'Start' (see page 25).
−
Wait until the tag tuning process is completed.
Attention! Do not use RFID interfering materials to realize the distance between the tag and the Antenna.
Index
Hanskamp AgroTech B.V. (The Netherlands)
24 - 46
www.hanskamp.nl/en
Spider
Advertisement
Table of Contents
