Table of Contents
Advertisement
EN
Feeding computer - Voercomputer - Fütterungscomputer - Logiciel d'alimentation
4.2 Adding and configurating SpiderPCB
Go to 'Maintenance' and log in with the administrator password.
Then go to 'Settings'
'Configuration SpiderPCB'. The below screen will open (figure 1).
->
1
Select the SpiderPCB (fig. 1) to be configured
Select 'Add' if no SpiderPCB is displayed or if an additional one needs to be added.
Then the next screen will open (figure 2).
Select the number of feeding stations you want to add, as well as the number of feed types per feeding station. Select the
motor type. Note: these are preconfigured settings and can be changed in the next screen. Once the selection has been
made, click 'Apply'.
2
The screen will open as shown in figure 3. Configure your feeding station here.
Click on 'Predefined layout' to choose from the most common formats.
Change the address, description and settings if necessary.
3
Index
Hanskamp AgroTech B.V. (The Netherlands)
.
The screen will open as shown in figure 3.
22 - 46
www.hanskamp.nl/en
Spider
Advertisement
Table of Contents
