Trane CVRC-M-1D Manual page 85

CVRC-M-1D
Service Test Group
Condenser Water Flow Switch Status
The following screen is not a setpoint. This screen displays the status of
the condenser water flow switch status at the input to the UCM.
Condenser Water Flow Switch Status:
Possible values for [y] are: Open (No Flow).
Closed (Flow).
Starter Dry Run
Note: Feature not functional when Pilot Relays are used with Starter
Module.
The following will be suppressed if starter type is set to "Stand Alone - No
Startup Module".
Use following screen when [XX] = "Disabled".
Starter Dry Run:
Press <+> <-> To Change Setting
Use the following screen when [XX] Not equal to "Disabled".
Starter Dry Run:
Press <+> <-> To Change Setting
Possible values for [XX] are: Disabled; Factory Default Shorting Relay
On, Run Relay On, Start Relay On, Transition Relay On, Start and Run
Relays On
Possible values for [Y] are: Closed This denotes that the Transition
Complete input is seeing a contact closure.
Open This denotes that the Transition Complete input is seeing a contact
open.
If the unit is not in the local stop mode the following is displayed.
Unit Must Be In Local Stop To Execute
Oil Pump
The following will be displayed only if Oil Pressure Setpoint is set to
differential transducer.
Oil Pump:
Differential Oil Pressure
Possible values for status are: On, Factory Default is Auto.
Differential Oil Pressure is not a setpoint but a status display.
Oil Pump
The following will be displayed only if Oil Pressure Protection Setpoint is
set to differential switch.
Oil Pump:
Diff Oil Press Sw Status
Possible values for status are: On, Factory Default is Auto.
Possible values for [Y] are: Open and Closed
[Y]
Starter Dry Run, Disabled
[XX]
[XX]
[Status]
XX.X PSID
[Status]
[Y]
85