Component Names And Functions; Front View - Omron SYSMAC C200HW-PCU01 Operation Manual

Component Names and Functions

4-2

Component Names and Functions

4-2-1 Front View

Front cover
 PC card slot
Name and Function of Each
Component
This section describes the name and function of each component of a PC Card
Unit.
 Indicator section
 CPU bus interface connector
 Plate 1 mounting hole
 Plate 2 mounting hole
Plate 3 mounting hole
The page numbers in parentheses indicate where relevant procedures are
explained.

Front cover (p.29)
Open the front cover when setting the system switch or connecting the Ethernet
setup cable.
 Indicator section (p.28)
The indicators show the current operation status.
 PC card slot (p.40)
A PC card is mounted in this slot.
 CPU bus interface connector (p.36)
This connector allows data exchange with the Programmable Controller. Use
the C200HW-CE011 or C200HW-CE012 Bus Connection Unit to connect the
PC Card Unit to the Programmable Controller.
 Plate 1 mounting hole (p.39)
This screw hole is used to fix Plate 1 to secure a Bus Connection Unit in place.
 Plate 2 mounting hole (p.41)
This screw hole is used to fix Plate 2 to secure a PC Card in place.
Plate 3 mounting hole
This screw hole is used to fix Plate 3 to secure the adapter cable attached to the
Ethernet Card.
System switch (p.29)
This DIP switch is used to set the startup mode, memory card format, format slot,
and operating level. It is also used to start formatting a memory card.
Serial communications connector (p.81)
This connector is used to set up Ethernet. Connect the personal computer used
for setup to the serial communications connector. The signal pin layout is the
same as that of the Host Link connector.
Serial
communications
connector
(When front cover is opened)
Section 4-2
System switch
27