File Delete; File Copy - Omron SYSMAC C200HW-PCU01 Operation Manual

PC Card Unit Commands and Responses
11-2-10

FILE DELETE

Command Block
Parameters
Response Block
11-2-11

FILE COPY

Command Block
Parameters
182
Deletes files stored in a file device connected to the PC Card Unit.
22 05
Command Disk no.
code
Disk no. (command): Specify the file device (memory card) as follows:
G drive (slot 1): $0006 H drive (slot 2): $0007
No. of files (command): The number of files to be deleted
File name (command): The names of the files to be deleted (in capital letters).
Set as: File name of up to eight letters + period + 3-letter extension. One-byte
alphanumeric code is used. When there are not enough letters to fill all 12 bytes,
fill the remaining bytes with spaces ($20).
Command Response
code code
No. of files (response): The number of files that have been deleted.
Note 1. The specified files will be deleted in sequence. If nonexisting file names
have been specified, the PC Card Unit will ignore them and the operation will
continue.
2. If the specified number of files and the number of file names do not coincide
no files will be deleted.
Response code
Refer to Appendix E FINS Response Codes from the PC Card Unit.
Copies a file onto the memory card of the PC Card Unit.
Note Do not create any files on the memory card that begin with "TMP...". The system
uses this prefix.
Command
code
Disk no. (command): Set the file device (memory cards) as follows:
G drive: $0006
File name (command): The file to be copied and a new name for the copied file.
Set as: File name of up to eight letters + period + 3-letter extension. One-byte
Shift JIS alphanumeric code is used. When there are not enough letters to fill all
12 bytes, fill the remaining bytes with spaces ($20).
12 bytes
No. of File name
files
No. of
files
12 bytes 12 bytes
File name (Destination)
Disk no. (Destination)
File name (Source)
Disk no. (Source)
H drive: $0007
Section 11-2
12 bytes
File name