Omron SYSMAC C200HW-PCU01 Operation Manual page 94

Installing and Removing the Ethernet Card
Installation Precautions
Removing an Ethernet Card
1, 2, 3...
78
For the PC Card Unit Ethernet Set, consider the lengths of the cable and plate 3
indicated in the figure below to ensure that there is sufficient room to install the
Ethernet Set properly.
Consider the length of this cable to ensure that there is
sufficient room to install the Ethernet Set.
1. Remove the set screw, then remove plate 2.
2. Remove the set screw, then remove plate 3.
3. Press the eject button as shown in the figure below.
The card inserted into slot 2 can be removed or installed by loosening the set
screws on plate 2. When removing or installing a card into slot 1, always
remove plate 2.
Note Do not press the eject button with the plates mounted.
Plate 3
Section 7-2
Backplane