Setup Software Operation; Preset Items; Starting And Exiting The Software - Omron SYSMAC C200HW-PCU01 Operation Manual

Setup Software Operation

7-6

Setup Software Operation

Preset Items

7-6-1
Preset Items

7-6-2 Starting and Exiting the Software

Before starting Ethernet communications through the Ethernet card, use the
setup software to set up the Ethernet communications environment.
Note Before setting up the Ethernet communications environment, connect the PC
Card Unit to the personal computer and copy the setup software as described in
7-4 Personal Computer Setup.
The items set using the setup software are described on the following pages.
Menu
1. Enter IP address for UNIT
2. Enter Subnet address for UNIT
3. Enter ODI Driver Path.
4. Edit HOSTS File.
5. Edit Conversion Table for IP address
and FINS Node address
6. Edit Routing Table for FINS.
7. Edit Gateway address for UNIT
8. Transfer Setup Data From Computer
to UNIT
9. Exit
This section describes how to start and exit the setup software.
Note 1. Before starting the setup software, copy all files from the setup floppy disk to
the hard disk. Before copying the setup software, make sure that the copy
destination does not contain any files that have the same file names as
those in the setup software.
Section 7-6
Description
Specify the IP address of the PC Card
Unit.
Specify the subnet mask of the PC Card
Unit.
Specify the file name (including the
extension ".COM") of the ODI driver
provided with the Ethernet card. Copy
the ODI driver file to the same directory
as the setup software beforehand.
Set the HOSTS file for the IP network.
To do so, you can copy the existing
HOSTS file or create a new HOSTS file.
Insert a space between the IP address
and host name. The maximum number
of lines in the HOSTS file is 127.
Specify the conversion correspondence
between each pair of a FINS node
address and IP address. Specify IP
addresses in decimal notation. Note that
if 0 is added to the beginning of each
field, the address will be interpreted as
an octal number. Enter a space between
the IP address and node address.
Specify the data required for
internetwork communication. The data
consists of a local network table and a
relay network table. Even if there is only
one network, specify just the local
network table. If the PC Card Unit is to
communicate with a node on another
network, the relay station must be a
CV-series PC.
Enter the IP address to be used as a
gateway with other Ethernet networks.
Transfer the data specified using the
setup software to the PC Card Unit.
Exit the setup software to return to the
DOS prompt.
87