Odi Driver; Hosts File - Omron SYSMAC C200HW-PCU01 Operation Manual

Setup Software Operation

7-6-5 ODI Driver

1, 2, 3...

7-6-6 HOSTS File

90
3. Make sure that the subnet mask is correct. Then, enter Y and press ENTER.
The screen will return to the main menu. To cancel the setting, enter N and
press ENTER to return to the main menu.
Specify the ODI driver to be used with the Ethernet card.
1. Select "3. Enter ODI Driver Path." from the main menu.
.
.
Select Number for ITEM (1–9): 3
Current ODI Driver : OC–NET–N.COM
New ODI Driver:
2. Enter an ODI driver name (including the extension ".COM").
The drive and the directory cannot be specified. Only the filename must be
specified.
New ODI Driver : ce2odi.com
: ce2odi.com May I setup current data? (Y/N)
3. Make sure that the ODI driver name is correct. Then, enter Y and press
ENTER. The screen will return to the main menu. To cancel the setting,
enter N and press ENTER to return to the main menu.
If the specified driver is not in the directory in which SETUP was executed, the
following message will be displayed.
: ce2odi.com Not found.
Press ENTER to return to the main menu.
Check the name of the ODI driver to be used, then repeat Step 1 to 3.
Note Specify only the file name for the name of the ODI driver. Copy the file to the
same directory as the SETUP.EXE beforehand.
Edit the HOSTS file as described below.
If a HOSTS file already exists in your personal computer, copy the file before-
hand. In each record of the HOSTS file, enter the IP address, a space, and the
host name in this order. Up to 127 nodes can be specified. An existing HOSTS
file can be used, but the maximum number of lines is still 127.
Example:
128.0.1.2 submaster
IP address Host name
Space
Section 7-6