Xerox DocuPrint P1202 Service Manual page 66

Replacement
NOTE: When you reassemble the Heat rod, ensure that the Heat Rod is properly seated.
1 If installing a new Heat Rod, handle the Heat Rod only by the ends. Do not touch the glass part of
the Heat Rod (Figure 4.4.1f).
2 Install the Heat Rod and terminal.
3 Reinstall the Fuser Assembly ensuring that the Exit Sensor Actuator is not damaged and has
free movement.
4 Complete the assembly in reverse order.
Repair Procedures
Figure 4.4.1f Seating the Heat ARod.
3/99
www.printcopy.info
4-24
egl_354a
Xerox DocuPrint P1202 Service Manual