Xerox DocuPrint P1202 Service Manual page 147

12 Disconnect the AC power. Reconnect the AC power and measure the voltages in Table 7.3. The
voltages must be measured during the first 9 seconds after AC power is applied, with the Main
Drive Motor running. All the voltages in column 5 (interlock closed 1 to 9 seconds) are correct.
Y N
| Replace the Engine PWB (PL 7).
13 Replace the Main Drive Motor Assembly (PL 6).
Measure Voltage
from CN1 Pin
3
4
5
6
Xerox DocuPrint P1202 Service Manual
Table 7.3. Main Drive Motor Voltages
To Interlock Open
Frame Ground 24.4 +/- 2.0 VDC
Frame Ground 24.4 +/- 2.0 VDC
Frame Ground 24.4 +/- 2.0 VDC
Frame Ground 24.4 +/- 2.0 VDC
3/99
www.printcopy.info
Interlock Closed
(after 10 Seconds)
23.8 +/- 0.5 VDC
23.8 +/- 0.5 VDC
23.8 +/- 0.5 VDC
23.8 +/- 0.5 VDC
7-7 Repair Analysis Procedures (RAP)
Interlock Closed
(1 to 9 Seconds)
21.8 +/- 1.0 VDC
21.8 +/- 1.0 VDC
21.8 +/- 1.0 VDC
21.8 +/- 1.0 VDC