Xerox DocuPrint P1202 Service Manual page 145

22 Request the customer to set the RCP Page Tab to 2nd Cassette. Press and hold the Front Panel
Key until all four LEDs flash. Release the Front Panel Key. Paper is fed from the lower Paper
Tray.
Y N
| Go to RAP 7.11.
23 The printer appears to be functioning properly. If the customer reported a Status Monitor Fault /
Message that has not been corrected, see Table 7.2. Status Monitor Fault / Message Table.
Status Monitor Message
On Line
Off line
Warming Up
Paper Tray Open or Empty
Cover Open or Missing
Printer Cartridge
Paper Jam 0
Paper Jam 1
Paper Jam 2
Scanner Error (LASER)
Fuser Error
Input/Output (I/O) Error
Memory Full
Band Error
Port Not Available
Unknown Status
Xerox DocuPrint P1202 Service Manual
Table 7.2. Status Monitor Fault / Message Table.
Normal Operation, no action required.
Press the Front Panel Key to go Online. The Ready LED is illuminated.
Normal Operation, fuser is warming to operating temperature.
Place paper in the paper tray. Ensure that the paper tray is fully inserted into the
printer. Verify that the paper empty actuator moves freely. Replace the Engine
PWB (PL 5).
Verify that the Printer Cartridge is properly installed. Verify that the Front Cover is
properly closed. Verify that the printer cartridge/front cover interlock actuator
moves freely. Replace the Engine PWB (PL 5).
Go to RAP 7.6.
Go to RAP 7.6.
Go to RAP 7.6.
Replace the LASER Assembly (PL 4).
Replace the Fuser Heat Rod (PL 5). Replace the Fuser Assembly (PL 5). Replace
Print Engine PWB (PL 7).
Inspect printer cable for damage and for proper connection, replace if necessary.
Cable supports bi-directional operation. Verify settings of host computer match
printer settings. Replace the System Controller PWB (PL 7).
Print job too large for printer memory. Add additional memory to printer or reduce
the page complexity.
Print job too large for printer memory. Add additional memory to printer or reduce
the page complexity.
Communications problem, go to RAP 7.9.
Using the DCU, verify the Laser and Fuser operation, replace if necessary (PL 4 )
or (PL 5).
3/99
www.printcopy.info
7-5
Corrective Action
Repair Analysis Procedures (RAP)